Project Description
ODF for Fibers
- Capacity up to 200 fibers, made of low carbon steel laminated steel. Epoxy paint with medium thickness 60-80m.
- Available in 19 “rack according to CEI 297 standard, with the possibility of anchoring it also to the wall.
- Inlet and outlet holes for fibers on both sides of the ODF and in both the lower and upper parts.
- These holes are dimensioned for a correct transit by them of the maximum amount of fibers that the ODF can manage. Face orifice has a useful surface of approximately 75cm2.
- Rubber weatherstripping of fiber inlet and outlet holes.
- Central partition that divides the ODF into two halves, with SC-APC or similar type double adapters. These boxes are divided into two columns of double box, with silkscreen identification in each of the columns.
- The ODF has front screen printing indicating the row number of each connector.
- Fiber numbering labels on both ODF doors.
- Ease of handling and storage of fibers due to the construction and position of the elements that make it up.

- Model 1: 100 adapters (200 fibers), 6 Over-Lenghts for the storage of the fibers, distributed 3 to each side of the central partition and 4 rings to guide the fibers. 20U height approx.
- Model 2: 64 adapters (128 fibers), 4 Over-Lenghts for the storage of the fibers, distributed 2 on each side of the central partition and 4 rings for guiding the fibers. 13U height approx.
- Model 3: 48 adapters (96 fibers), 4 Over-Lenghts for the storage of the fibers, distributed 2 on each side of the central partition and 4 rings for fiber guidance. 13U height approx.
- Model 4: 32 adapters (64 fibers), 2 Over-Lenghts for the storage of the fibers, distributed 1 on each side of the central partition and 2 rings for fiber guidance. 7U height approx.
- Model 5: 16 adapters (32 fibers), 2 Over-Lenghts for the storage of the fibers, distributed 1 to each side of the central partition and 2 rings to guide the fibers. 7U from height approx.
